Giulia

Clip-on cover that blocks the light gap around the sun-visor retaining point while preserving normal visor operation. The creator explicitly identifies 2018-and-later Alfa Romeo Giulia and Stelvio fitment and recommends PETG, ABS or ASA for summer cabin heat.

Fits Giulia · Tipo 952 · Stelvio · Tipo 949

Clip-on shield for the original forward-collision radar cover to reduce water, dirt and snow accumulation. The creator explicitly states Alfa Romeo Stelvio and Giulia fitment and reports testing at all sensitivity settings without affecting operation. Remove it immediately if any radar or driver-assistance warning appears.

Fits Giulia · Tipo 952 · Stelvio · Tipo 949

Console-mounted phone holder sized for an iPhone 12 Mini with a protective case. The creator explicitly states Alfa Romeo Stelvio and Giulia fitment and recommends PETG or ABS because cabin heat can deform PLA. Confirm device clearance and secure retention before driving.

Fits Giulia · Tipo 952 · Stelvio · Tipo 949

Printable repair and alignment jig for rebuilding broken left- or right-side fog-lamp mounting tabs. The creator identifies Giulia and Stelvio fitment and calls for two-part structural plastic adhesive. This is an alignment aid, not a printable lamp or lens.

Fits Giulia · Tipo 952 · Stelvio · Tipo 949

Replacement cover for a lost or broken ISOFIX access-opening flap on 2018-and-later Giulia and Stelvio rear seats. This is non-structural trim and must not obstruct the child-seat anchor.

Fits Giulia · Tipo 952 · Stelvio · Tipo 949

Replacement passenger-side trim cover around the seat-adjustment controls. The creator explicitly identifies Giulia and Stelvio fitment; verify switch clearance before use.

Fits Giulia · Tipo 952 · Stelvio · Tipo 949

Longer and less bulky interior-mirror attachment variant for the creator’s Giulia phone-mount system, providing additional adjustment range.

Fits Giulia · Tipo 952

Adapter for mounting a Sony Xperia Z5 Compact at the interior-mirror location. It is the phone-side companion to the creator’s Giulia mirror attachment.

Fits Giulia · Tipo 952

Replacement actuator finger for the glovebox latch. The creator made it for a Giulia Quadrifoglio after the original plastic actuator failed. Check latch release and retention before closing the glovebox.

Fits Giulia · Tipo 952

Clip for 7.5 mm Lumenition Performance high-tension ignition leads used on Alfa Romeo Tipo 105 cars. Confirm lead diameter, avoid sharp bends, and keep the clip clear of hot or moving engine components.

Fits 1750 / 2000 Berlina · 1750 Berlina (105.48) · 1750 / 2000 Berlina · 2000 Berlina (105.12) · Giulia · Tipo 105 / 115 Berlina +5

Replacement spacer for the speedometer drive where the cable connects on Alfa Romeo Tipo 105 cars. The creator copied an original spacer, printed it in ASA, and reports successful fit and operation.

Fits 1750 / 2000 Berlina · 1750 Berlina (105.48) · 1750 / 2000 Berlina · 2000 Berlina (105.12) · Giulia · Tipo 105 / 115 Berlina +5

Replacement clamp/spacer securing heater-control cables to the heater levers in Alfa Romeo Tipo 105 and 115 cars. The creator printed PETG at full infill and suggests checking shrinkage and lever movement after installation.

Fits 1750 / 2000 Berlina · 1750 Berlina (105.48) · 1750 / 2000 Berlina · 2000 Berlina (105.12) · Giulia · Tipo 105 / 115 Berlina +8