Jeep vehicle line
Choose the precise generation for verified fitment, or browse all 133 parts currently associated with this vehicle line.
Fitment
All generations
C3D–00774Complete repair set for the missing or cracked center and side vents in a 2002 TJ, including housings, vanes, sliders and geared control pieces. The creator printed prototypes and specifies heat-resistant material for service use.
Fits Wrangler · TJ
C3D–00808Modular Wrangler JL dashboard-rail mounting set with heat-resistant printable bases, arms, 20 mm ball adapters, magnetic base, and left/right holders for 67 Designs-compatible rails.
Fits Wrangler · JL
C3D–00711Printable rear lamp housing with deeper lens-screw holes, a wiring opening and internal rails for the included red-and-clear lens separator. The source recommends heat-resistant material and provides both printable parts.
Fits CJ · CJ-5 · CJ · CJ-7 · CJ · CJ-8 Scrambler +1
C3D–00777Auxiliary round-rocker switch panel shaped to the curved radio bezel used on 2011–2018 Wrangler JK and JKU interiors. Installation requires holes behind the panel.
Fits Wrangler · JK
C3D–00719Driver- and passenger-side replacement handles for paddle-style doors. The creator tested the design in a 1981 CJ-7 and states YJ and TJ compatibility, while warning that earlier non-paddle doors differ.
Fits CJ · CJ-7 · Wrangler · YJ · Wrangler · TJ
C3D–00703Three-piece replacement cupholder with a 3.5-inch front pocket, a 1.91-inch rear pocket and a separate base that can be glued or screwed in place.
Fits Wrangler · YJ
C3D–00701Replacement end clip for broken mechanical heater-control cables. The creator verified it on 1991 controls and identifies select CJ, YJ and XJ applications; fit and cable travel should be checked before reassembly.
Fits Cherokee / Liberty · XJ · CJ · CJ-5 · CJ · CJ-7 +2
C3D–00798Low-profile fog-light mount for a Wrangler JK aftermarket bumper where a winch interferes with the factory cup. It moves the original fog lamp forward approximately 13 mm.
Fits Wrangler · JK
C3D–00789Holder for a 14 mm aftermarket hands-free microphone in the factory UConnect microphone position of a Wrangler JK. Rounded and squared holder variants are included.
Fits Wrangler · JK
C3D–00807Outer bushing that fits a Hi-Lift jack climber rung around the Rampage carrier bolt to suppress rattling. The creator states JK and JL fitment.
Fits Wrangler · JK · Wrangler · JL
C3D–00802Printable hand knob assembly for Wrangler JK Freedom-panel bolts. It captures an M8 × 1.25 × 75 mm bolt for tool-free panel retention.
Fits Wrangler · JK
C3D–00799Right-hand passenger sun-visor pivot mount modeled after the broken mount in a Wrangler JK. It allows repair without replacing the complete visor assembly.
Fits Wrangler · JK