Range Rover Classic

Holds the seatbelt latch so it does not slide down past the shoulder. Universal to any seatbelt of standard width. (3MF file)

Fits Defender · 200 Tdi · Defender · 300 Tdi · Defender · Td5 +8

Workshop fitting tool for seating the rear hub seal squarely.

Fits Defender · 200 Tdi · Defender · 300 Tdi · Defender · Td5 +3

52mm hub nut socket for a wide range of Land Rover models. Most wheel bearings only need gentle torque - a few later models use the same nut but with huge torque and this likely won't work for those. 1/2" socket plus a 27mm (wheel nut) sized hex on the back. Designed to be printed without supports. Print in something robust.

Fits Defender · 200 Tdi · Defender · 300 Tdi · Discovery · 1 +5

Simplified, smaller front bumper corner for the full-size Range Rover Classic 200Tdi. Attaches using the original screw. Confirm side and dimensions against the vehicle before printing.

Fits Range Rover · Classic

Simplified fixed replica of the original Range Rover Classic dashboard vent grille. The source model is based on a full-size Classic and is intended to be glued in place.

Fits Range Rover · Classic

Replacement fuse-box cover for the full-size Range Rover Classic.

Fits Range Rover · Classic

Replacement protective sleeve for the Range Rover Classic heated rear-window cables, Land Rover part 589818. The source author changed the original round section to a square section and tuned the curvature for fit. PETG or nylon is preferable to brittle PLA. LR3DParts converted the original ASCII STL to binary STL without changing its geometry for upload compatibility.

Fits Range Rover · Classic

Replacement clips for the Range Rover Classic plastic access-panel doors beneath the front seats. Includes a friction-fit version and a version with a retaining lip. Attach with a small Command strip or glue

Fits Range Rover · Classic

Interior lamp cover for the full-size Range Rover Classic. Print with supports. Replace the incandescent bulb with an LED before fitting so heat does not deform or melt the printed cover.

Fits Range Rover · Classic

Simplified 78 mm centre hub cap for Range Rover Classic alloy wheels. Prints without supports.

Fits Range Rover · Classic

Dashboard blanking plate for a full-size Range Rover Classic when no car radio is installed.

Fits Range Rover · Classic

Fuse cover designed for an approximately 1993 Range Rover Classic 200Tdi. Uses one M3 x 25 screw. This is the screw-retained alternative to the standard fuse-box cover.

Fits Range Rover · Classic