Series 2

A cup holder that clips to the metal dash of a Series 1-2a.

Fits Series · 1 · Series · 2 · Series · 2A

Three-part replacement socket assembly for an indicator or position lamp using a separate single-contact bulb holder. Verify the 33 mm housing fit, wiring, insulation, and weather sealing.

Fits Series · 1 · Series · 2 · Series · 2A +1

Six-piece replacement kit redrawn from surviving original plastic and bakelite wiper-motor components. The positive-terminal insulator uses a simplified M3 through-bolt connection.

Fits Series · 1 · Series · 2 · Series · 2A

Originally built to mount a Bolt&Trim Leather speaker holder for the Marshall speaker. This allows for a temporary/movable mount based originally on a cup holder. Could be easily modified for other speaker styles.

Fits Series · 1 · Series · 2 · Series · 2A

Replacement UP–DOWN heater airflow control button. Compare the lever slot and lettering orientation with the original before printing and fitting.

Fits Series · 2 · Series · 2A · Series · 3

52mm hub nut socket for a wide range of Land Rover models. Most wheel bearings only need gentle torque - a few later models use the same nut but with huge torque and this likely won't work for those. 1/2" socket plus a 27mm (wheel nut) sized hex on the back. Designed to be printed without supports. Print in something robust.

Fits Defender · 200 Tdi · Defender · 300 Tdi · Discovery · 1 +5

Door-hinge packing shims in three thicknesses. They also separate dissimilar metals to help reduce electrolytic corrosion

Fits Series · 2 · Series · 2A

Replacement ventilator control knob modelled from the original component.

Fits Series · 2

Bulkhead-mounted holder for a standard 33 cl can, with a recess for an optional 6 mm retaining magnet.

Fits Series · 1 · Series · 2

Three-piece 12-volt inspection-lamp socket adaptation using standard 4 mm RC bullet connectors, 14 AWG silicone wire, and an M3 x 12 mm fastener.

Fits Series · 1 · Series · 2

Eleven thickness variants of the isolating shim fitted between the chassis brackets and rear tub to separate dissimilar metals.

Fits Defender · 200 Tdi · Defender · 300 Tdi · Defender · Td5 +5

Workshop mandrel for centring the clutch plate during assembly. Confirm the spigot and spline diameters against the gearbox input shaft and clutch before use.

Fits Series · 2 · Series · 2A · Series · 3

Replacement COLD–WARM heater control button. Compare the lever slot and lettering orientation with the original before printing and fitting.

Fits Series · 2 · Series · 2A · Series · 3

Replacement bush used with a standard 5/16-inch bolt and locking nut to align the brake shoes. Tap the printed bore to suit the bolt thread and follow the source adjustment method.

Fits Series · 1 · Series · 2 · Series · 2A +1