Model S First generation

I needed cupholders for the middle seats of my Tesla Model X. This fits the 2020 6-seater seats and hooks onto the seat next to the seat belt holders as shown in the picture. The cupholder size is designed to fit a 32oz or 40oz Hydroflask. I used Prusaslicer and created a support enforcer just for the hook part, no other supports. Printed at 0.3mm with Prusament PETG. Category: Automotive. Free 3D printable car part STL: Hydroflask cup holder for Tesla Model X 6 seater seats for Tesla Model X.

Fits Model X · First generation

Fold-down cargo-net hook placed beneath the trunk shelf.

Fits Model Y · First generation

Lidded enclosure for hiding excess wiring from an interior LED kit in the center-console armrest area.

Fits Model Y · First generation

Tray for the 2021 forward center console with the sliding door; the creator distinguishes it from the under-armrest compartment.

Fits Model Y · First generation

Mount for positioning a radar detector above the center screen. V2 increases rear contact area; the creator suggests optional double-sided foam tape and warns that retention is not fully proven and screen damage is possible.

Fits Model Y · First generation

Narrow removal tool for lug-nut caps recessed in Gemini wheels where ordinary pliers do not fit.

Fits Model Y · First generation

Female retainer clip and locking pin for the front mudflaps. The creator specifies horizontal printing with supports, 100% infill, and black PETG.

Fits Model Y · First generation

Two-piece cover for the tow-hitch receiver opening.

Fits Model Y · First generation

Pair of screw-retained hangers for storing umbrellas beneath the rear parcel shelf; designed for approximately 16 mm mounting holes.

Fits Model 3 · First generation

Clip-in under-dash mount for the optional power-liftgate button; it uses an existing trim-clip location and requires no tools or hardware according to the creator.

Fits Model 3 · First generation

Eight-piece glove-compartment assembly fitted inside the dashboard trinket tray to retain small items.

Fits Roadster · First generation

Center-console holder that retains an iPhone 5 in 2.0 vehicles.

Fits Roadster · First generation

Console-dock adapter that charges and retains an iPhone 5 during driving in 2.x vehicles.

Fits Roadster · First generation

Adapter that replaces the original iPhone dock connector in the 2.5 center-console dock.

Fits Roadster · First generation

Four-piece left/right front mud-guard set remixed for M3 square nuts and M3x10 mm screws. The creator thickened each backplate by 2 mm and reports the set fitted the available wheel-liner gap.

Fits Model 3 · First generation

Flexible replacement spacer for a missing exterior door-handle insert that restores the handle's flush position. The creator specifies TPU, 200°C, 10 mm/s, and 15% infill.

Fits Model 3 · First generation

Two-piece holder that relocates the trailer-hitch electrical plug directly to the tow hook for short cables. The creator specifies M6 and M5 screws, separate car- and hitch-side connectors, and a cable with at least nine wires.

Fits Model 3 · First generation