Toyota vehicle line
Choose the precise generation for verified fitment, or browse all 18 parts currently associated with this vehicle line.
All generations
C3D–00486Two-piece dashboard-trim mount for securing a Baofeng UV-5R handheld radio in the fifth-generation Toyota GR Supra, with a fitted trim clip and separate radio cradle.
Fits Supra · 5th Gen
C3D–00485Clip-in insert for the fifth-generation Toyota GR Supra centre-console cupholder, using the factory spring-loaded tabs and supplied in plain and accessory-cutout variants.
Fits Supra · 5th Gen
C3D–00484Three-piece fitted bass-reflex port and protective speaker-mesh set for the fifth-generation Toyota Supra rear subwoofer enclosure, designed to vent into the boot and reduce bass resonance.
Fits Supra · 5th Gen
C3D–00483Two fitted dashboard-trim mounts for the fifth-generation Toyota GR Supra, supplied in angled and flat versions for attaching a MagSafe charging puck.
Fits Supra · 5th Gen
C3D–00482Workshop alignment tool for centring the clutch disc on a Toyota Supra 2JZ and W58 transmission combination before the pressure plate is tightened.
Fits Supra · 4th Gen
C3D–00481Adapter for installing Audi switch 8D0941563 in the right-hand-drive Toyota Supra Mk4 right-side centre-panel switch position
Fits Supra · 4th Gen
C3D–00480Adapter that uses the factory three-point front-speaker mounting holes in a fourth-generation Toyota Supra to install a four-inch speaker without modifying the original enclosure
Fits Supra · 4th Gen
C3D–00479Replacement blanking cover for the centre or left switch opening in the 1993–1998 Toyota Supra JZA80 centre console.
Fits Supra · 4th Gen
C3D–00478Replacement clip for securing the fourth-generation Toyota Supra headliner using hook-and-loop fastener material
Fits Supra · 4th Gen
C3D–00477Modular replacement for the third-generation Supra ashtray, combining a side-positioned gauge pod with a choice of 100 mm or 125 mm storage pocket and the required back plate and spacer.
Fits Supra · 3rd Gen
C3D–00476Replacement moving latch for the third-generation Supra centre-console cup holder. Light sanding or cleanup may be needed for smooth movement.
Fits Supra · 3rd Gen
C3D–00475Replacement left and right lower-back finish trims, vibration-isolating end pads and optional mounting nut for the facelift third-generation Supra centre taillight panel. Use strong, vibration-resistant filament for the trims, soft TPU for the pads, and provide a separate watertight seal at the outer mounting holes.
Fits Supra · 3rd Gen