S60

Full-size replacement headlight-washer cover for the 2006 Volvo S60 first generation. The cover fits over the front-bumper headlight-washer nozzle; the corroborating source notes that supports under the clips are required and reports testing in PETG (spelled "PTEG" in the indexed note). Verify the nozzle tabs and bumper fit before installation and paint to match as needed. Source: jedas, Creative Commons - Attribution.

Fits S60 · First generation

Drop-in organizer for the Volvo S60 first-generation tunnel console, with a coin holder, credit-card holder, pencil slot, and multiple small pockets. The creator specifies no print material; PETG is an engineering-inferred material choice for cabin heat. Verify trim variant, dimensions, fit, retention, clearances, and unobstructed access before use. Source rights are CC BY-NC-SA 4.0: attribution, noncommercial-only use, and ShareAlike apply.

Fits S60 · First generation

Replacement roof/load-bar pad for Volvo V70 and S60 P2 applications named by the creator. The part protects the load-bar mounting points. The creator does not specify a print material; TPU is engineering-inferred for a flexible, weather-exposed pad. Verify the carrier profile and fit before road use.

Fits S60 · First generation · V70 · Second generation · V70 · Third generation

Printable reproduction of Volvo special tool 9995449 for installing a front camshaft seal squarely and to the specified depth. The source includes flush, +1 mm, and +2 mm variants; the creator recommends PLA, at least 50% infill, and at least 3 perimeters, and says the original bolts can be reused. The creator warns that printed/plastic tools can shatter or break: inspect the print, use appropriate protection, and verify the applicable Volvo procedure before use. The +1 mm and +2 mm deeper variants are not approved by the cited manual according to the creator.

Fits S60 · First generation

Full-size functional replacement trunk tie-down/bag hook accessory. The creator identifies fitment for the 2019 Volvo S60 and vehicles using Volvo child part 39835508; insert the stem into the trunk clip body and twist to lock it in the rectangular trunk opening. The source model was printed with PLA and recommends PETG at least or ABS for automotive use. Verify fit, secure retention, clearances, and load suitability before use; this is not a certified cargo-restraint anchor.

Fits S60 · Third generation

Full-size functional replacement headlamp-washer cap holder/retainer for the first-generation Volvo S60 (2000–2009), based on the creator’s fitment statement and reported multi-year use. The source identifies original unit/retainer number 30655462, is free to download under CC BY, and requires attribution. Source-recommended materials are PETG or ASA; PETG is mapped here because ASA is not present in the active material snapshot. Verify side, nozzle/cover interface, dimensions, print orientation, heat/weather resistance, and fit before installation.

Fits S60 · First generation

Functional two-file cup-holder insert for P3 Volvo XC60/S60, source-stated 2011-2017 fitment. The source images show the printed ring installed in the center-console cup-holder location and retaining a beverage can. Verify model year, chassis/console variant, fit, retention, clearances, and material suitability before use. The creator did not specify filament; PETG is engineering-inferred for cabin heat resistance. CC BY attribution terms apply.

Fits S60 · Second generation · XC60 · First generation