Find your next part.

Replacement plastic screw-retaining clip for the removable panel below the headlamp on 1996–2000 vehicles.

Fits Tacoma · 1st Gen

Replacement clip for securing the front turn-signal assembly, with provision for an M3 retaining screw.

Fits Tacoma · 1st Gen

Replacement corner and side support brackets for the factory-style tray tonneau-cover support structure.

Fits Hilux · 8th Gen

Replacement wing nut for retaining the original air-cleaner assembly, designed from a 1988 pickup.

Fits Hilux · 4th Gen

Replacement support bracket beneath the four-wheel-drive selector trim and centre console on right-hand-drive vehicles, supplied as a one-piece model and a support-reduced two-piece alternative.

Fits Hilux · 6th Gen

Replacement support bracket beneath the four-wheel-drive selector trim and centre console on left-hand-drive vehicles.

Fits Hilux · 6th Gen

Replacement trim cover for the windscreen-wiper arm pivot.

Fits Hilux · 5th Gen

Replacement side-marker bulb housing and body gasket designed to accept a Dorman 85814 type 194 bulb socket while retaining the original coloured lens.

Fits Hilux · 3rd Gen

Keyed adapter for retaining the original front parking sensor behind an 18 mm opening in an aftermarket steel bumper.

Fits Lexus GX · 460-400

Bracket for retaining an aftermarket welcome light in an original frame mounting hole after removal of the running boards.

Fits Land Cruiser Prado · 120 Series · Lexus GX · 470

Replacement clear lens for the interior light above the rear deck.

Fits 4Runner · 1st Gen

Replacement clip that secures the front grille to the body.

Fits 4Runner · 1st Gen

Bracket for attaching a small auxiliary light to the factory roof rail, with an integral wiring channel and cable-management loops.

Fits 4Runner · 4th Gen

Replacement bushings and keeper for the upper rear-hatch gas-strut mounting pin, with factory-style and revised versions.

Fits 4Runner · 3rd Gen

Clip-on brace that holds the rear hatch fully open when worn gas struts can no longer support it.

Fits 4Runner · 3rd Gen

Three-piece brace, locating ring and locking wedge for mounting a 50-amp electrical quick-disconnect socket in the grille on 1990–1995 vehicles.

Fits 4Runner · 2nd Gen

Three-piece brace, locating ring and locking wedge for mounting a 175-amp electrical quick-disconnect socket in the grille on 1990–1995 vehicles.

Fits 4Runner · 2nd Gen

Replacement mounting bracket for the rear camera.

Fits Lexus LX · 470

Left- and right-hand two-piece inner housings for repairing brittle side-marker assemblies, with alternate bulb-socket openings and blank editable socket source.

Fits Land Cruiser · 60 Series

Three replacement plastic fasteners for the grille, lamp and bulb-holder positions on a 1987 vehicle.

Fits Land Cruiser · 60 Series

Replacement grommet and retaining catch for the bonnet support rod. The creator recommends weather- and heat-resistant material.

Fits Land Cruiser · 60 Series

Replacement interior-light cover and flexible gasket for fitting a low-cost LED panel in place of the original lamp assembly.

Fits Land Cruiser · 60 Series

Slightly oversized 16 mm bonnet-hinge bush intended to reduce movement and rattling in worn hinge carriers. Print with strong layer bonding and high infill

Fits Series · 3

Replacement plunger for a broken fuel-filler-door actuator.

Fits Discovery · 3 · Discovery · 4 · Range Rover Sport · L320