Find your next part.

Fitted block that turns the narrow centre-console pocket into divided storage for coins, pens and other small items.

Fits 4Runner · 5th Gen

Low-profile rear dash-camera mount that reuses the original headliner fastener and provides a pad for a Viofo-style camera.

Fits 4Runner · 5th Gen

Mount for replacing the sunglasses holder with a six-switch sPod controller on vehicles without crawl control.

Fits 4Runner · 5th Gen

Two dashboard inserts: one holds a replacement accessory-power socket or USB charger, and the other accepts a 52 mm auxiliary gauge.

Fits 4Runner · 2nd Gen

Replacement latch for the centre-console storage box, modelled for the BJ73.

Fits Land Cruiser 70 Series · Mark I

Bracket for installing a 2 1/16-inch Speedhut or similarly sized 53 mm tachometer in the original instrument cluster.

Fits Land Cruiser · 60 Series

Rear support bracket for the power-seat threaded drive rod. The creator recommends full infill and notes that the centre bore may need adjustment.

Fits Land Cruiser · 80 Series · Lexus LX · 450

Deeper replacement pocket for the opening above the stereo, with a rear cable pass-through.

Fits Land Cruiser · 80 Series

Replacement latch for the storage box between the front seats.

Fits Land Cruiser · 80 Series · Lexus LX · 450

Three cup-holder insert variants for the square centre-console opening, including a larger rounded recess and a version with an accessory slot.

Fits Land Cruiser · 80 Series

Replacement blanking plug for unused rectangular dashboard switch positions.

Fits Land Cruiser · 80 Series

Threaded replacement cap for the power-seat drive screw.

Fits Land Cruiser · 80 Series · Lexus LX · 450

Panel for installing a USB socket beside the rear-heater switch or in place of the coin holder in the centre console.

Fits Land Cruiser · 80 Series

Console for mounting auxiliary switches or other equipment in the small driver-side dashboard recess. Blank and pre-drilled versions are included for both left- and right-hand-drive vehicles

Fits Defender · L663

Base-plate adapter for fitting GMC/Chevrolet pickup tie-down anchors to the cargo-area ceiling. Installation uses two 3/8 × 1.5-inch carriage bolts with washers and nuts.

Fits Defender · L663

Replacement threaded button for the handbrake lever. The source recommends finishing the undersized bore with an M5 tap for a secure fit.

Fits Series · 2A · Series · 3

Replacement COLD–WARM heater control button. Compare the lever slot and lettering orientation with the original before printing and fitting.

Fits Series · 2 · Series · 2A · Series · 3

Three-part loadspace-light conversion comprising an installation template, switch panel, and blanking plate. Wiring polarity and switching differ between early and later vehicles, so verify the circuit before modification.

Fits Freelander · 2

Two-piece coin organiser for the centre-console area, comprising a main holder and lid.

Fits Freelander · 2

Replacement end cap for the passenger roof grab handle, measured from a 2000 four-door vehicle.

Fits Freelander · 1

Four-part fascia, side-bracket, and brace set for installing an aftermarket double-DIN stereo in the 2008 dashboard.

Fits Range Rover Sport · L320

Two-part centre-console cup holder with an enlarged approximately 75 mm internal diameter and no phone pocket. Designed from a related holder and explicitly stated to fit this generation.

Fits Discovery · 1

Replacement cover for the window-switch panel on three-door vehicles. Confirm switch layout and panel dimensions before printing.

Fits Discovery · 1

Phone holder designed to sit in the front coin tray, sized around an iPhone 11 in an Apple case. Confirm phone and tray dimensions before printing and use a heat-resistant cabin material.

Fits Range Rover · L322