Find your next part.

Replacement support bracket for the instrument cluster where the original is missing or damaged. Compare handedness, hole spacing, and dashboard structure before printing.

Fits Series · 3

Slightly oversized 16 mm bonnet-hinge bush intended to reduce movement and rattling in worn hinge carriers. Print with strong layer bonding and high infill

Fits Series · 3

Replacement threaded button for the handbrake lever. The source recommends finishing the undersized bore with an M5 tap for a secure fit.

Fits Series · 2A · Series · 3

Replacement COLD–WARM heater control button. Compare the lever slot and lettering orientation with the original before printing and fitting.

Fits Series · 2 · Series · 2A · Series · 3

Modular dashboard base with two M6 attachment points, plus compatible Garmin and Motorola device holders. The base attaches to the vinyl dashboard with automotive-grade double-sided tape.

Fits Series · 3

Replacement lower-dashboard air vent in the later flat style.

Fits Series · 3

Replacement plastic control for the Lucas wash/wipe switch. The sacrificial lower support can be removed after printing

Fits Series · 3

Replacement bush used with a standard 5/16-inch bolt and locking nut to align the brake shoes. Tap the printed bore to suit the bolt thread and follow the source adjustment method.

Fits Series · 1 · Series · 2 · Series · 2A +1

Three-part loadspace-light conversion comprising an installation template, switch panel, and blanking plate. Wiring polarity and switching differ between early and later vehicles, so verify the circuit before modification.

Fits Freelander · 2

Deep dashboard-console mount for integrating a seven-inch tablet. Installation requires electrical adaptation and modification of the tablet controls

Fits Freelander · 2

Multi-part workshop tool for removing and installing the cabin blower motor. It requires M5 threaded rod, nuts, bolts, and bonded inserts

Fits Freelander · 2

Bolt-on lower clip and rotating sleeve for repairing the glovebox damper. Install with an M3 × 16 mm fastener, nut, and locking washer, and orient the clip for strength as shown by the source.

Fits Freelander · 2

Replacement internal gear set for a failed tailgate-lock actuator. Three printable variants are included

Fits Freelander · 2

Support ring fitted beneath the fuel-cap thread seal to improve compression and help prevent evaporative-system leaks.

Fits Freelander · 2

Replacement cap for the windscreen-washer reservoir.

Fits Freelander · 2

Two-piece overlay repair for a broken glovebox-damper attachment. The body clips over the damaged damper and a half-ring lock provides additional retention.

Fits Freelander · 2

Two-piece coin organiser for the centre-console area, comprising a main holder and lid.

Fits Freelander · 2

Replacement plunger for a broken fuel-filler-door actuator.

Fits Discovery · 3 · Discovery · 4 · Range Rover Sport · L320

Replacement quarter-turn retaining clip for the rear tow-hitch cover.

Fits Range Rover Sport · L320

Flexible replacement overlay for worn key-fob buttons. Two versions are included: a partial overlay and a full button-hole overlay. Print in a flexible material with a fine nozzle.

Fits Range Rover Sport · L320

Two replacement locating-pin variants for the loadspace cover: one for an M8 opening and one for the original 11 × 11 mm square opening. Print horizontally to reduce delamination risk.

Fits Range Rover · L322

Replacement end piece for a longitudinal roof rail.

Fits Range Rover · L322

Push-fit cap for covering an unused roof-rack mounting hole.

Fits Discovery · 3 · Discovery · 4

Two-part centre-console organiser comprising a main tray and removable divider. Use a cabin-temperature-resistant material because PLA may soften in summer heat.

Fits Discovery · 3