Find your next part.

Replacement ball connector for the 1984–1986 Celica Supra fog-light adjustment assembly, reported successfully printed and fitted by its designer.

Fits Supra · 2nd Gen

Replacement front-grille clip for the second-generation Celica Supra, using a short piece of filament as the transverse retaining pin.

Fits Supra · 2nd Gen

Mirrored left- and right-hand replacement radiator-support extensions for the second-generation Celica Supra, modelled from an original part and reference photographs.

Fits Supra · 2nd Gen

Reinforced replacement clip that retains the hood-release cable at the latch mechanism, designed and installed on a 2007 vehicle.

Fits Sequoia · 1st Gen

Two-piece dashboard phone mount for second-generation Sequoia SR5 models, using the small console pocket absent from Platinum trim. The cradle accepts a compact Qi charging puck.

Fits Sequoia · 2nd Gen

Replacement volume-control knob for the factory rear-seat entertainment system in the second-generation Toyota Sequoia.

Fits Sequoia · 2nd Gen

Replacement protective grille for the FJ Cruiser snorkel intake, with standard and flat-backed printable variants.

Fits FJ Cruiser · XJ10

Replacement trim plug for the automatic-transmission gear-selector assembly.

Fits FJ Cruiser · XJ10

Heat-resistant replacement cap for the exposed windshield-wiper arm pivot fastener.

Fits FJ Cruiser · XJ10

FJ-specific centre-console storage sleeve with a phone-sized main pocket and optional small bottle and gum-container attachments.

Fits FJ Cruiser · XJ10

Replacement hinged cover for the cabin 12-volt cigarette-lighter power outlet.

Fits FJ Cruiser · XJ10

Two sizes of fitted roof-panel plugs for covering the factory roof-rack mounting openings on the 2007 FJ Cruiser.

Fits FJ Cruiser · XJ10

Flat-faced replacement dashboard and console switch blank with clear rear space for installing a small switch, indicator or accessory.

Fits FJ Cruiser · XJ10

Three-piece replacement shell and button insert for the 2007 FJ Cruiser remote-key electronics.

Fits FJ Cruiser · XJ10

Two-piece replacement centre cap for the cabin armrest, assembled with an M3 by 8 mm screw.

Fits FJ Cruiser · XJ10

FJ-specific PanaVise mounting plate for a Baofeng F8HP or smaller handheld radio, supplied in tapped-hole and heat-set-insert variants.

Fits FJ Cruiser · XJ10

Fitted removable cover for the open centre-console box, with a cable-routing gap and clearance for levelling pads.

Fits FJ Cruiser · XJ10

Replacement knob for the FJ Cruiser heater and air-conditioning controls, retained with an M3 socket-head screw.

Fits FJ Cruiser · XJ10

Flexible sheath that restores the keyring attachment on a broken factory key fob, designed and fitted for a 2004 vehicle.

Fits Sequoia · 1st Gen

Two-piece phone mount using an ashtray slide modelled for 2002–2006 vehicles and a cradle sized for the Samsung Galaxy S9+.

Fits Sequoia · 1st Gen

Ashtray-slot mounting base for a GOXT sliding phone holder, designed for 2002–2006 first-generation vehicles.

Fits Sequoia · 1st Gen

Adapter ring designed for a first-generation vehicle to install a smaller replacement speaker in the factory speaker location.

Fits Sequoia · 1st Gen

Low-support ScanGauge mount that replaces the ashtray and was redesigned around a 2006 vehicle

Fits Sequoia · 1st Gen

Flexible replacement support that secures the brake-vacuum hose to the remaining factory bracket post, modelled and installed on a 2006 vehicle.

Fits Sequoia · 1st Gen