Find your next part.

Replacement end piece for a longitudinal roof rail.

Fits Range Rover · L322

Push-fit cap for covering an unused roof-rack mounting hole.

Fits Discovery · 3 · Discovery · 4

Replacement receiver that grips the quarter-turn plastic screw securing the rear tow-bar cover.

Fits Discovery · 3 · Discovery · 4

Replacement pair for cracked rear loadspace-cover brackets.

Fits Discovery · 1

Two-piece fixing for securing the loadspace carpet.

Fits Freelander · 1

Press sleeve for fitting a support bearing onto the viscous-coupling unit while loading the bearing inner race.

Fits Freelander · 1

No-drill rear-camera holder that replaces one number-plate-light position. Confirm camera dimensions, cable routing, and local lighting requirements before installation.

Fits Freelander · 1

Replacement threaded carpet retainer.

Fits Freelander · 1

Replacement cover for a locking wheel nut.

Fits Freelander · 1

Four-part fascia, side-bracket, and brace set for installing an aftermarket double-DIN stereo in the 2008 dashboard.

Fits Range Rover Sport · L320

Replacement retaining clip for the rear tow-hitch cover and related exterior panels.

Fits Range Rover Sport · L320

Dashboard cradle sized for an iPhone X and designed around the 2012 cabin layout.

Fits Range Rover Sport · L320

Angled roof-console pod for two 52 mm gauges. Installation requires trimming part of the original mating flange and securing the pod with small countersunk screws.

Fits Discovery · 1

Three-part replacement sun-visor retainer for either side. Print the body flat, the clip prongs upward, and the cap with its tube upward, then glue the clip into the body before installation.

Fits Discovery · 1

Two-part centre-console cup holder with an enlarged approximately 75 mm internal diameter and no phone pocket. Designed from a related holder and explicitly stated to fit this generation.

Fits Discovery · 1

Bolt-on repair pieces for parcel-shelf eyelets that have torn through. Requires trimming the shelf and two M3 x 7 mm fasteners

Fits Discovery · 1

Replacement left-hand cover for the power-seat switches on a 1996 vehicle. The ribbed design differs slightly from the original

Fits Discovery · 1

Reinforced replacement bracket for a broken rear parcel shelf. Compare side and mounting geometry with the original before printing.

Fits Discovery · 1

Protective bung for a factory Westfalia detachable-towbar receiver, intended to keep dirt and moisture out when the hitch is removed. Check receiver dimensions before printing.

Fits Range Rover · L322

Replacement internal bar for a broken cabin heater and air-conditioning vent grille. Confirm vent position and dimensions against the original before printing.

Fits Range Rover · L322

Two-part holder and lid for mounting a Nexus 9 tablet in a 2002–2012 dashboard installation, suitable for an Android Auto client or other tablet-based interface. Editable OpenSCAD sources are included.

Fits Range Rover · L322

Replacement retaining clip for the plastic wind deflector mounted beneath each front wiper arm on 2002–2012 vehicles. Use a weather- and UV-resistant material.

Fits Range Rover · L322

Adapter that allows compatible standard 22-inch wiper blades to fit the L322 front wiper arm without additional hardware. The source recommends ABS, three perimeter walls, 40% infill, and supports.

Fits Range Rover · L322

Bolt-on adapter for the side-arm front wiper fitting used on 2003–2012 vehicles, converting it to accept a conventional cross-bar blade attachment. Includes editable OpenSCAD source.

Fits Range Rover · L322