Find your next part.

Replacement bushings and keeper for the upper rear-hatch gas-strut mounting pin, with factory-style and revised versions.

Fits 4Runner · 3rd Gen

Clip-on brace that holds the rear hatch fully open when worn gas struts can no longer support it.

Fits 4Runner · 3rd Gen

Three-piece brace, locating ring and locking wedge for mounting a 50-amp electrical quick-disconnect socket in the grille on 1990–1995 vehicles.

Fits 4Runner · 2nd Gen

Three-piece brace, locating ring and locking wedge for mounting a 175-amp electrical quick-disconnect socket in the grille on 1990–1995 vehicles.

Fits 4Runner · 2nd Gen

Replacement latch for the centre-console storage box on 1990–1995 vehicles.

Fits 4Runner · 2nd Gen

Three-piece console extension for a VDJ79 pickup, with a pen slot, drink holder, glasses pocket, dual-USB socket position, business-card dispenser, phone pocket, removable utility tray and hidden storage. It joins with a dovetail and fits between the original console and cup holder without vehicle modification.

Fits Land Cruiser 70 Series · Mark IV

Replacement knob for the second-row audio-control unit in the centre console, with a 4.85 mm inner bore for a nominal 4.7 mm shaft.

Fits Lexus LX · 470

Separate front- and rear-door spacers for installing 8-inch aftermarket speakers while preserving window-glass clearance.

Fits Land Cruiser · 100 Series

Replacement mounting bracket for the rear camera.

Fits Lexus LX · 470

Five-piece replacement for the original small cup holder, split for compact printers and designed for larger cups and bottles. The left- and right-hand upper pieces can be mirrored for left-hand-drive fitment.

Fits Land Cruiser · 100 Series · Lexus LX · 470

Clip for mounting a 31 mm Element fire extinguisher, flashlight or similar cylindrical item to a 26.1 by 4.9 mm seat-bracket crossbar.

Fits Land Cruiser · 60 Series

Left- and right-hand two-piece inner housings for repairing brittle side-marker assemblies, with alternate bulb-socket openings and blank editable socket source.

Fits Land Cruiser · 60 Series

Three blanking-plug variants for the small and large dashboard switch openings, including a small plug with a centre hole.

Fits Land Cruiser · 60 Series

Three replacement plastic fasteners for the grille, lamp and bulb-holder positions on a 1987 vehicle.

Fits Land Cruiser · 60 Series

Replacement grommet and retaining catch for the bonnet support rod. The creator recommends weather- and heat-resistant material.

Fits Land Cruiser · 60 Series

Replacement interior-light cover and flexible gasket for fitting a low-cost LED panel in place of the original lamp assembly.

Fits Land Cruiser · 60 Series

Pair of rails for replacing the ashtray with a CB radio or another accessory approximately 115 mm wide.

Fits Land Cruiser · 60 Series

Insert for the front compartment of the factory centre console, with two 72 mm cup recesses and a vertical phone slot.

Fits Land Cruiser · 60 Series

Interference-fit insert for the opening above the radio, with interchangeable mounts for a hands-free microphone and magnetic phone holder. The revised body includes pockets for two 5/16 by 1/8 inch retaining magnets.

Fits Land Cruiser · 80 Series

Bulkhead-mounted holder for a standard 33 cl can, with a recess for an optional 6 mm retaining magnet.

Fits Series · 1 · Series · 2

Stable funnel that sleeves over the 18 mm AdBlue filler tube and rests on the adjacent air intake. It has approximately half-litre capacity, 3 mm debris-filter holes, an air-escape tube to prevent glugging, and a measured gravity-flow rate of about two litres per minute. A separate 1.7-litre pouring jug is included.

Fits Range Rover · L405

Two replacements for the unused 1998 centre-panel opening: a plain plug and a post-mounted version for a small air freshener.

Fits Defender · 300 Tdi · Defender · Td5

Three-piece adaptor set for fitting a 1995 Ford F-150 throttle-position sensor to a 1994 3.9-litre V8 throttle body. The creator specifies PETG for engine-bay heat resistance.

Fits Defender · 300 Tdi

Replacement interior end cap for the roof reinforcement bar.

Fits Defender · 200 Tdi · Defender · 300 Tdi · Defender · Td5 +1