Find your next part.

Workshop driver for installing the front crankshaft seal in an Alfa Romeo 2.0 L Nord engine. Check the driver's seating face against the new seal and use controlled force; it is an installation tool, not an in-service engine component.

Fits Giulia GT / GTA · Tipo 105 / 115 Coupes

Workshop tool for centering piston rings in an 84 mm cylinder bore while checking end gap. The 84 mm size is corroborated for the Alfa Romeo 2000 GTV's 1,962 cc engine; confirm the measured bore before use.

Fits Giulia GT / GTA · Tipo 105 / 115 Coupes

Workshop fixture that mounts to the six-bolt rear crank flange of an Alfa Romeo 2.0 L Nord engine for controlled rotation during assembly. Print in PETG at full infill as the creator recommends; never use it to start or run an engine.

Fits Giulia GT / GTA · Tipo 105 / 115 Coupes

Workshop alignment tool for the pressure plate and clutch on Alfa Romeo Tipo 115 GTV coupes. Verify pilot and hub diameters against the removed clutch before assembly; this is an installation aid, not an in-service vehicle part.

Fits Giulia GT / GTA · Tipo 105 / 115 Coupes

Two source-provided replacement connector variants for the cabin heater vents in 1970–1976 Alfa Romeo 2000 GTV/unificato Bertone coupes. Compare the original connector and select the matching variant before installation.

Fits Giulia GT / GTA · Tipo 105 / 115 Coupes

Clip for 7.5 mm Lumenition Performance high-tension ignition leads used on Alfa Romeo Tipo 105 cars. Confirm lead diameter, avoid sharp bends, and keep the clip clear of hot or moving engine components.

Fits 1750 / 2000 Berlina · 1750 Berlina (105.48) · 1750 / 2000 Berlina · 2000 Berlina (105.12) · Giulia · Tipo 105 / 115 Berlina +5

Replacement spacer for the speedometer drive where the cable connects on Alfa Romeo Tipo 105 cars. The creator copied an original spacer, printed it in ASA, and reports successful fit and operation.

Fits 1750 / 2000 Berlina · 1750 Berlina (105.48) · 1750 / 2000 Berlina · 2000 Berlina (105.12) · Giulia · Tipo 105 / 115 Berlina +5

Replacement clamp/spacer securing heater-control cables to the heater levers in Alfa Romeo Tipo 105 and 115 cars. The creator printed PETG at full infill and suggests checking shrinkage and lever movement after installation.

Fits 1750 / 2000 Berlina · 1750 Berlina (105.48) · 1750 / 2000 Berlina · 2000 Berlina (105.12) · Giulia · Tipo 105 / 115 Berlina +8

Flexible replacement floor bung or blind grommet for 1960s–1970s Alfa Romeo Tipo 105 and 115 vehicles. Print in TPU and verify the opening size and retention before road use.

Fits 1750 / 2000 Berlina · 1750 Berlina (105.48) · 1750 / 2000 Berlina · 2000 Berlina (105.12) · Giulia · Tipo 105 / 115 Berlina +6

Printable left- and right-side map-pocket shells, back plate, and edge trims intended to be covered with vinyl; the back plate is made from 1–1.5 mm aluminium sheet.

Fits Giulia GT / GTA · Tipo 105 / 115 Coupes