Nissan

Replacement protective cap for the rear wiper arm, covering the exposed arm hardware at the rear window. Intended for the 2013–2021 Qashqai/Dualis J11 generation (North American Rogue Sport application); verify arm geometry, retention, and clearance before use.

Fits Qashqai / Dualis · J11

Four-piece set of printed repair components that restores the mounting points on a rear hatch handle by replacing broken internal clip blocks and reusing the original handle hardware. The set includes left- and right-side clip components plus inner and connector pieces for the Qashqai / Dualis J10 (2006-2013) application. The printed parts are bonded to the original handle and require fit checking before installation.

Fits Qashqai / Dualis · J10

Engine-bay bracket for mounting the coolant reservoir after removal of the factory fuse-box mounting location on the Nissan S13/180SX/200SX/240SX family. The printed part provides the reservoir support interface; the reservoir and fastening hardware are not included. Use a heat- and weather-resistant material suitable for engine-bay service and verify fit, clearance, and secure retention before operation.

Fits Nissan 180SX · RS13/RPS13 · Nissan Silvia · S13

Door-mounted spacer ring for installing a 165 mm (6.5-inch) aftermarket speaker in the front door speaker location of the Nissan March/Micra K11 (1992–2002). The ring increases clearance for a less-shallow speaker and provides the vehicle-side and speaker-side mounting interfaces; the speaker, wiring, fasteners, locknuts, and shims are separate components. Verify the exact speaker diameter, mounting depth, hole alignment, window and trim clearance, wiring routing, fastening, and vibration isolation before installation.

Fits March · K11

Two interchangeable full-size intake adapters for mounting CA18DET or SR20DET mass-airflow sensors to compatible A'PEXi filters. Includes separate SR20 and CA18 adapter geometries and requires a 3 mm O-ring cord assembled into the seal groove; printed parts only, with filter, sensor, O-ring cord, and hardware not included. Fits S13, S14, and S15 applications with the corresponding MAF and filter interfaces; verify sensor variant, sealing, fastener engagement, intake clearance, and engine-bay heat resistance before use.

Fits Nissan Silvia · S13 · Nissan Silvia · S14 · Nissan Silvia · S15

Replacement center-console armrest USB pass-through cover that replaces the factory USB socket surround and lets a Lightning cable pass through while routing the cable to an under-armrest interface. Includes the printed cover only; the cable, tie, and any electronics are separate. Fitment is verified for the Nissan GT-R R35 (2007-2025). Creator guidance specifies Nylon CF and recommends against PLA for hot vehicle interiors; verify the connector, cable tie, armrest opening, and clearances before installation.

Fits Nissan GT-R · R35