car3dparts.

Nissan vehicle line

Nissan 180SX

Choose the precise generation for verified fitment, or browse all 5 parts currently associated with this vehicle line.

Fitment

Generations

All generations

Nissan 180SX parts

Open filtered catalog →
Coolant Reservoir Mounting BracketC3D–02653
NissanCooling, fuel & exhaust

Coolant Reservoir Mounting Bracket

Engine-bay bracket for mounting the coolant reservoir after removal of the factory fuse-box mounting location on the Nissan S13/180SX/200SX/240SX family. The printed part provides the reservoir support interface; the reservoir and fastening hardware are not included. Use a heat- and weather-resistant material suitable for engine-bay service and verify fit, clearance, and secure retention before operation.

Fits Nissan 180SX · RS13/RPS13 · Nissan Silvia · S13

Dashboard Gauge PodC3D–02631
NissanDashboard & controls

Dashboard Gauge Pod

Full-size replacement pod for the dashboard vent opening, mounting below the dash and accepting either a 52 mm or 60 mm gauge. The packet includes the standard base, mirrored base, 52 mm insert, and 60 mm V2 insert; two M4x30 bolts and two M4 nuts are required separately. The design is intended as a reversible replacement without cutting or drilling. PETG or ABS are engineering-inferred for cabin heat resistance; verify gauge fit, retention, clearances, and print strength before driving.

Fits Nissan 180SX · RS13/RPS13 · Nissan Silvia · S13

Radiator Support BracketC3D–02630
NissanCooling, fuel & exhaust

Radiator Support Bracket

Full-size radiator support mounting bracket for Nissan Silvia S13 and 180SX RS13/RPS13 applications, with the source also identifying 200SX and 240SX market variants. The bracket mounts at the front radiator support and retains the radiator with the corresponding vehicle hardware. Includes one printed bracket; verify exact market/body variant, hole spacing, fasteners, clearances, and engine-bay heat and vibration suitability before installation.

Fits Nissan 180SX · RS13/RPS13 · Nissan Silvia · S13

Fuel Line Holder SetC3D–02629
NissanCooling, fuel & exhaust

Fuel Line Holder Set

Four-piece set of replacement holders for routing and retaining underbody fuel lines on Nissan 180SX RS13/RPS13 and Nissan Silvia S13 applications. The selected OEM-replacement variant includes Halter 1 E, Halter 2 E, Halter 3 E, and Halter 4 E; print duplicates as needed for the vehicle's layout. This variant retains the fuel lines and the original evap/fuel-tank venting line. Verify line routing, fastener fit, clearance, and print strength on the specific vehicle before installation.

Fits Nissan 180SX · RS13/RPS13 · Nissan Silvia · S13

Radio Bezel Retaining ClipsC3D–02628
NissanDashboard & controls

Radio Bezel Retaining Clips

Full-size replacement clips for the radio-console/bezel mounting interface. The set includes single-clip and multi-pack variants for Nissan 180SX RS13/RPS13 and Silvia S13 applications represented by the selected catalog generations; the clips restore retention of the radio-console bezel when original clips are missing or broken. PETG is recommended for vehicle-cabin use, while ABS was used for the earlier prints.

Fits Nissan 180SX · RS13/RPS13 · Nissan Silvia · S13