Subaru

3D-printable holder for a Samsung Galaxy Note 9. The printed rail mounts between the radio and dashboard/vent area and supports the phone in front of the center vents. Verified fitment covers 2012-2016 Impreza and 2013-2017 Crosstrek vehicles. The printed holder is the modeled component; the phone and any non-printed mounting hardware are not included.

Fits Impreza · Fourth generation (GJ/GP) · XV / Crosstrek · First generation (GP)

Clip-on dashboard vent mount for a Garmin GPS/navigation unit in the center vents of the 2015 Subaru Outback (fifth generation, BS). The flexible clip straddles the emergency-flasher button area while preserving access to the vents and can be moved between the two center vents; the updated version has reduced pivot range compared with the original clip and is intended to print vertically with tree supports. The vehicle and GPS device are not included.

Fits Outback · Fifth generation (BS)

Full-size cup holder for the dashboard ashtray/blanking-panel opening on a 1997 Subaru Sambar KS4. It provides a 66 mm opening for cans and, with the removable filler washer removed, approximately 71 mm clearance for larger cups or bottles while clearing the manual gear lever. The model includes the cup-holder body and removable filler washer; confirm the dash opening, shift-lever clearance, retention, and print strength before installation.

Fits Sambar · Fifth generation (KS3/KS4/KV3/KV4)

Full-size adapter for mounting an HKS SQV 4 blow-off valve to the factory recirculation plumbing, returning discharged air to the intake system. Verified fitment is the fourth-generation Subaru Legacy BL/BP (2003-2009) with the compatible valve and flange arrangement. Intended for engine-bay service; print in ABS, ASA, or PA-6 CF and verify gasket seating, hose routing, clamp retention, and clearances before operation.

Fits Legacy · Fourth generation (BL/BP)

Three-gauge dashboard mount for the center dash lid of the 2009 Forester. The mount provides three instrument-gauge openings, uses a drilling template to locate the mounting holes, and attaches with four M4 screws. The selected files include the current pod body and the drilling-template component; gauge diameter and hardware supply were not verified.

Fits Forester · Third generation (SH)

Two alternative full-size phone-mount variants for the center-console coin pocket of the 2018 Subaru Outback fifth generation (BS). One variant uses a 1.25-inch slot interface and the other provides a flat face for an adhesive-backed mount. Printed parts only; phone, adhesive mount, and mounting hardware are not included. Verify pocket interface, device clearance, retention, cable routing, and unobstructed visibility before driving.

Fits Outback · Fifth generation (BS)