Impreza Fourth generation (GJ/GP)

3D-printable holder for a Samsung Galaxy Note 9. The printed rail mounts between the radio and dashboard/vent area and supports the phone in front of the center vents. Verified fitment covers 2012-2016 Impreza and 2013-2017 Crosstrek vehicles. The printed holder is the modeled component; the phone and any non-printed mounting hardware are not included.

Fits Impreza · Fourth generation (GJ/GP) · XV / Crosstrek · First generation (GP)

Cap-style oil-filter removal wrench for vehicles using Subaru filter 15208AA15A. It seats around the filter canister to aid hand removal during oil changes; verify the filter number and fit before applying torque. The packet contains one wrench geometry.

Fits Ascent · First generation (WM) · Forester · Third generation (SH) · Forester · Fourth generation (SJ) +12

Full-size two-section adapter for a factory front center-console cup-holder opening. It enlarges the opening to retain a 40 oz water bottle; the printed geometry has approximately 95 mm upper inner diameter, 70 mm lower inner diameter, and a 100 × 145 mm overall envelope. Use a heat-resistant filament such as PETG or ASA; the source print guidance specifies no supports.

Fits Impreza · Third generation (GE/GH/GR/GV) · Impreza · Fourth generation (GJ/GP) · WRX · First generation (VA) +2

Full-size replacement hood support-rod retaining clip for the 2011-2016 Subaru Impreza (GJ/GP) represented by generation 1199. It secures the hood prop rod in its retaining position. Print in PETG at 100% infill as specified for the model, and verify rod diameter, clip engagement, hood clearances, and secure retention before road use.

Fits Impreza · Fourth generation (GJ/GP)

Console organizer tray with a cord pass-through opening and integrated coin compartments for the upper center-console storage area. Verified fitment: 2012-2017 Subaru XV/Crosstrek first-generation GP and 2012-2016 Subaru Impreza fourth-generation GJ/GP.

Fits Impreza · Fourth generation (GJ/GP) · XV / Crosstrek · First generation (GP)

This is a printable replacement for a Subaru Impreza hood support rod end cap - or whatever you want to call the plastic part that fits into the hood slot when the rod is raised. This piece (white piece in picture) broke on our 2016 Impreza and Subaru seems to only sell the entire rod, not just the cap piece, so I decided to take a whack at modeling and printing a new one. I'm new to Fusion 360, so it took a few tries, but this one is working nicely for me. I'm not sure which other Subaru models/years this would work for, but there's not really much to it, so if it looks like the part in the picture, you can give it a shot! The part is pretty close to the original, though I did beef it up a bit in the area where the original one broke. I also set infill at 50% which might be overkill, but it seemed better to overbuild. You'll need to print with supports, and be sure to have your xacto handy to do some somewhat fiddly cleanup. I printed this using Prusament Galaxy Black PLA, mainly because it's all I have on hand, but let's face it, the engine compartment of a Subaru Impreza could use a little glittery bling, right?

Fits Impreza · Fourth generation (GJ/GP)